What is best way to hook up two dual coil watt adieobahn - Fixya What is best way to hook up two dual coil watt adieobahn - Fixya

Dual 400 watt amp hook up, about this item

Choose a video to embed

Previously had the same amp and sub with zero distortion. Annie February 5, at 1: Additionally I would get a bass knob so you can have an independent sub level volume control as opposed to adjusting the bass on the head unit which will adjust bass levels to all speakers.

These have dual 2 ohm voice coils, allowing you to series the coils and parallel the subs, resulting in a 2 ohm load to you amp just like the MTX's and RF's recommended above. Frank June 22, at Mathew May 4, at 8: The question should be, can the two 15 inch sub-woofers handle Watts?

That is feeding the actual audio signal to the amp.

Yahoo ist jetzt Teil von Oath

I have a bass knob already that connects to the kicker amp that I want to install. Do I have to splice the LOC on both subs or just one? The bass is overpowering. I need to clean the heavily processed signals. They are powered by: How many watts is amps? I can understand wanting to keep the look stock.

Do i have to keep the harness plugged into the head unit or do i have to keep it unplugged as i read somewhere you cannot power the speakers from both factory hu and amp simultaneously.

Keith April 17, at Annie February 4, at 5: The stock set up was better than it is now. Hope to hear a response. Could this really be the case.

400 Watt Amplifier

I guess in this case they used a separate line output converter since you mentioned they used RCA cables. It is easy to do. Very good sound,if your not looking for a a fancy amp this is the one.

oleh-oleh khas singapura online dating

I was thinking of replacing them with Polk Audio components in the front and coaxial for the back. I may have missed it somewhere. You might want to would wait to see what JL comes up with, but it may be another 9 months or so before they release anything.

dating funny cartoons

This question cannot be answered without knowing the voltage. And they have so many variations!

Please turn JavaScript on and reload the page.

You would bridge the amps, it will cut into your power, but that's how you do it. How can you hook up another amp to your sub amp for your 6x9?

You can take the speaker leads off the back of the stock stereo and route them directly to your amp. I replaced the stock speakers and tried to get them amped.

fractionalization dating games

So in the future there may be some nice options. Hugo September 7, at 1: Radio volume cabln be cranked to the maximum. Let me know what happened. With this processor you also have the option of using a digital aux in so for a dedicated super high fidelity source, you can use an iPod running through a high quality digital to analog convertor straight into the processor.

Add Your Answer

If it does, that would indicate possibly a poor ground for the amplifier. Annie April 18, at 1: I hope that makes sense!

Had 4 wires going to that one sub. And whether it's sealed or ported, the enclosure needs to have enough internal volume for the particular sub you are planning to use. You could grab your audio signal right at the stock subwoofer in the Cadillac.